我正在使用ATmega4808 32针。我有2个LED分别连接到引脚PA0和PA1。我想把两者都设置得很高。不幸的是,只有PA1 LED点亮。
我发现默认情况下,PA0引脚可以设置为EXTCLK。如果这是问题,我找不到将端口更改为GPIO的解决方案。
int main(int argc, char** argv) {
PORTA.DIRSET = PIN0_bm; // Config PA0 as output
PORTA.DIRSET = PIN1_bm; // Config PA1 as output
PORTA.OUTSET = PIN0_bm; // Set Pin PA0 to HIGH
PORTA.OUTSET = PIN1_bm; // Set Pin PA1 to HIGH
while(1){
}
return (EXIT_SUCCESS);
}
答案 0 :(得分:0)
通过再次写入寄存器PORTA.DIRSET
和PORTA.OUTSET
来丢失PIN0的配置。
尝试使用| (bitwise OR)
不放弃PIN0配置:
PORTA.DIRSET = PIN0_bm; // Config PA0 as output
PORTA.DIRSET |= PIN1_bm; // Config PA1 as output
PORTA.OUTSET = PIN0_bm; // Set Pin PA0 to HIGH
PORTA.OUTSET |= PIN1_bm; // Set Pin PA1 to HIGH
或者,要同时设置它们:
PORTA.DIRSET = PIN0_bm | PIN1_bm; // Config PA0 and PA1 as output
PORTA.OUTSET = PIN0_bm | PIN1_bm; // Set Pin PA0 and PA1 to HIGH