我正在尝试设置静态IP地址。这是我的/ etc / network / interfaces:
# interfaces(5) file used by ifup(8) and ifdown(8)
auto lo
iface lo inet loopback
# primary network interfaces
auto eth0
iface eth0 inet static
address 192.168.1.88
netmask 255.255.255.0
network 192.168.1.0
broadcast 192.168.1.255
gateway 192.168.1.1
dns-nameservers 127.0.1.1
显然,我的机器根本没有eth0。我环顾四周,每个人都说用eth0配置上面的文件。有没有其他方法可以使用这些设备设置静态IP地址?
$ ifconfig -a
eno1: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether 1c:1b:0d:0a:86:00 txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 20 memory 0xdf400000-df420000
enp82s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.1.7 netmask 255.255.255.0 broadcast 192.168.1.255
inet6 fe80::9b71:b459:c8d8:4bc5 prefixlen 64 scopeid 0x20<link>
ether 1c:1b:0d:0a:85:fe txqueuelen 1000 (Ethernet)
RX packets 3712 bytes 2691239 (2.6 MB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 1501 bytes 157372 (157.3 KB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device memory 0xdf200000-df21ffff
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1 (Local Loopback)
RX packets 25268 bytes 1537593 (1.5 MB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 25268 bytes 1537593 (1.5 MB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
wlp83s0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether e4:b3:18:8c:05:87 txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
答案 0 :(得分:2)
是。只需将ajax
替换为其他接口之一。
例如:
HttpPost