Question

我想将我的Raspberry Pi设置为静态IP设备，它通过以太网进行通信（通过类似192.168.20.X的IP），同时它应该通过WLAN（192.168）连接到互联网。 1.1）。但是，当我允许'auto eth0'时，它不会配置wlan0。我希望他们两个都能工作。我目前的配置如下：

source-directory /etc/network/interfaces.d
auto lo

iface lo inet loopback

auto eth0  
iface eth0 inet static
 address 192.168.20.40
 netmask 255.255.255.0
 network 192.168.20.1
 gateway 192.168.20.1


allow-hotplug wlan0
iface wlan0 inet manual
wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf

allow-hotplug wlan1
iface wlan1 inet manual
wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf

我错过了什么？任何帮助，将不胜感激。提前谢谢。

解决：

source-directory /etc/network/interfaces.d
auto lo

iface lo inet loopback

auto eth0  
iface eth0 inet static
 address 192.168.20.45
 netmask 255.255.255.0
 network 192.168.20.1
 gateway 192.168.1.1    # Changing this worked
 dns-nameservers 8.8.8.8 8.8.4.4

allow-hotplug wlan0
iface wlan0 inet manual
wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf

allow-hotplug wlan1
iface wlan1 inet manual
wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf

Answer 1

<强>解决：

source-directory /etc/network/interfaces.d
auto lo

iface lo inet loopback

auto eth0  
iface eth0 inet static
 address 192.168.20.45
 netmask 255.255.255.0
 network 192.168.20.1
 gateway 192.168.1.1    # Changing this worked
 dns-nameservers 8.8.8.8 8.8.4.4

allow-hotplug wlan0
iface wlan0 inet manual
wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf

allow-hotplug wlan1
iface wlan1 inet manual
wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf

Answer 2

使用静态IP配置＆＃34; wlan0＆＃34;

它会正常工作

静态IP和自动wifi连接的网络配置

2 个答案: